Savings will appear in your shopping bag. This bed packs lots of storage in a more compact profile.

It's an updated approach to our most popular plan. Please do not attempt this bed as a beginner project with the drawers. Then all you have to do is make the cross cuts at home. These cuts are from the 3/4" thick plywood.From the remaining pieces, cut your remaining drawer faces as shown above.

You will need to either purchase an additional 1/2 sheet of plywood for the two remaining drawer bottoms, or you could use leftover 3/4" stock for the remaining two drawer bottoms.

You will do the same with the footboard panel. If you are using traditional screws, mark the legs where they meet up with the panel at the top and bottom (where the panel is covered in trim. Use a drill bit the size of the screw head to drill a hole 2" deep into the legs. In this hole, use a drill bit the size of the screw head to drill a second hole all the way through the 4x4s.

How to make a Doll Bed with Storage with foam board. Enjoy!

Subscribe for 5 New Videos Every Week!!!!

1 New Video Monday ...

Build square if you are using drawers or your drawers will not slide right. Make sure you nail into all center dividers too. The back will help keep things straight and minimize sagging. Take a minute and cut some leftover 4x4s or 2x4s 4" long and use them as blocking to hold the boxes up as you screw to the headboard and footboard. Screw from the inside of the boxes into the legs and supports. Some 2x2s "legs" as shown above will never be seen, but add a tremendous amount of support to the bed. Per your mattress recommendation, you may need more (or can get away with less) slats. Your drawers must be perfectly square to slide properly into the bed. Remember, your drawer should be exactly 1" less than the overall width of the opening, and 1" less deep as well. Make sure drawer sits inset 1" from outside of box to allow for drawer face. Adjust drawer slides until you are satisfied with how the drawer opens/closes. Place drawer face on installed drawers, with an 1/8" gap on all sides of drawer face. Attach with 1 1/4" finish nails and wood glue.

We have been looking for a bed with storage and a headboard. Can't wait to see what you come up with next, keep up the great work!

It's a complicated one, so make sure you read through everything before building.

I would highly recommend adding additional support to the center too - either framing up a 2x4 box for the center and laying plywood on it or running a center support down the center, with "legs" running off of it.

I had the tools and space to make this bed!!

Our customers shop with confidence knowing each doll case is crafted from high-quality components that have been safety tested to the highest governmental standards.


How To Make A Doll Bed With Storage


How to make a Doll Bed with Storage!

Enjoy!

Subscribe for 5 New Videos Every Week!!!!

Follow me on Instagram: ...

<